Before Robox, we had no ability to prototype brake bells. The only option for us was to send them for manufacture, assuming our measurements were correct.

As you can imagine, a few parts came back and didn't fit, costing us hundreds of pounds, and weeks in lost build time.

The other alternative for components like this would be to send one for manufacture, receive it to check the fit, then go ahead with the remaining parts. However, this again is fairly unfeasible due to time constraints, and would still have cost hundreds for the single brake bell to be potentially wrong.

Ultimately, if the whole set of bells were incorrect, it would have cost us something in the region of £2,000. Robox, in comparison, used around £2 of plastic, and reduced prototype time to a single day.

We can realistically say that our Robox printer paid for itself with this one job!

Tour De ForceMatt Scott, Design Engineer
Profile photo of Grant Mackenzie

About Grant Mackenzie

Grant is about Robox business development. He's based in CEL's head office. Contact Grant

Leave a Reply