This topic contains 3 replies, has 3 voices, and was last updated by 
Pete 13 hours, 54 minutes ago.
-
Posts
-
I installed the new version of Automaker but it stops after showing the splash screen. I tried and uninstall and reinstall, reboot etc. But it does not run. I went back to the previous version of Automaker. 🙁
@microcan Did you try a clean install? Did you open a support ticket? I know that V3 works fine on mac, but you have to give CEL a chance to help you as you have an issue somewhere with your system.
I operate two Betas and four Production Robox.
I am the US/Canada Technical Support engineer for the Robox.
See my 3D Hub site at https://www.3dhubs.com/phoenix/hubs/ben@microcan it may be a language problem.
Please try this:
http://www.cel-robox.com/forums/topic/automaker-wont-start/
Fixed using above link
You must be logged in to reply to this topic.
