Community testing: Quickfill

[Terry Taylor @n6mon My Robox is a Green Kickstarter Early Bird San Lorenzo, Ca, USA]

I put the quick fill profiles in the location specified and I can see them if I click on the … prompt to edit them, but I cannot select them in the drop down (and yes, I have the custom profile icon checked).

Terry Taylor

[Microcan @microcan My Robox is a Blue Commercial Version]

@pete

I do not see any speed improvement for QuickFill. Just 5 minutes

 

• This reply was modified 1 year, 7 months ago by  Microcan.

Attachments:

You must be logged in to view attached files.

[Sven @tuxontour My Robox is a Blue Commercial Version]

I also testet the quick fill profile and also created one myself. It seemed to use the same transport speed for the .3 and .8 mm nozzle.

That is under extruding by a factor of 8 to 9 leaving just pillars at the intersection of the fill-in at 20% setting.

[Andi Tran @aebi184]

Hi, i have a problem with my custom profiles.

Everytime i save a new custom quickfill profile it saves just some settings, but the extrusion width settings everytime get totaly lost and go back to minimum. The solid infill and top solid infill is out of order so cant be adjusted. Whats the matter here ?

Also is the 0.8mm infill very under extruding and the extrusion overlap is bad and mostly don’t overlap the perimeter layer. Everywhere are gaps. I tried to “cheat” with so much settings but i find out only the first few layers can be done with success. After approx 2mm print height it starts “under extrude” and every layer done more bad.

All things i tried fully calibrated with Original Robox Designer Grey ABS

[Shaun @saiken I have several commercial Robox units BC, Canada]

@siymon @pete Any traction on this post? Do the settings appear to function as expected? I’ll try them out if they can still be used.

[Author]

Posts