This topic contains 0 replies, has 1 voice, and was last updated by 
paulsroom 1 day, 19 hours ago.
-
Posts
-
Is it possible to obtain an official dimensioned drawing of the opening where the filament reels fit on the Robox? I want to make a cover that slides (no screws or clips) into the opening over the filament reels and encloses them. The aim is to protect the filament against moisture (as much as possible) when the Robox is not being used, but still has the filament in place. I would make a small cavity in the cover to fit a small packet of Silica Gel. While it may not be airtight, it would still provide some benefit. I could reverse engineer the opening by measuring it, but if a drawing is available then that is a more accurate starting point.
You must be logged in to reply to this topic.
