Some prints so far

[SuperChocolateBear @superchocolatebear]

So after a few dodgy prints to start off with (only one complete failure though), a blocked extruder and a day spent completely re-calibrating everything im getting some awesome prints, more to follow

Attachments:

You must be logged in to view attached files.

[SuperChocolateBear @superchocolatebear]

Missed a few

Attachments:

You must be logged in to view attached files.

[StreatSi @streatsi]

@superchocolatebear some nice prints. what material are they in? pla or abs and is that just using standard profiles?

[SuperChocolateBear @superchocolatebear]

Just what came with the printer….believe white is pla and green is abs, the mask, pumpkin and crossbow were done on draft quality and the rest on normal surprised at the high quality even on relatively low settings

[Medusa @medusadelft]

Really nice quality examples! I was worried after some prints shown here and all the problems mentioned. I almost cancelled my order, but seeing these photo’s I’m glad I didn’t. I’m now convinced the robox CAN produce good quality (I’ve seen more good prints recently), so I can’t wait till mine arrive.

Thanks for sharing.

[biscuitlad @biscuitlad]

@superchocolatebear - some nice prints there, well done. Does that pencil shooter thingy work OK? Downloaded it but haven’t printed it yet.

[SuperChocolateBear @superchocolatebear]

Yeah printed out well, some finishing and assembly required and the triggers a little tricky to get right, very tight fit and can be a little stiff as needs to be attached with screws, will fire right across the house though using a twisted rubber band

[Paul @carnivalius]

Very Nice! The small blobbing on your demon skull is probably from using the standard profile, if you were to print in fine they would disappear (at least from my experience).

[Author]

Posts